Closed
Description
Board
Adafruit ESP32 Feather - HUZZAH32
Device Description
Plain Module in breadboard
Hardware Configuration
Nothing attached to the dev board. Using USB power.
Version
v2.0.10
IDE Name
Arduino IDE
Operating System
Ubuntu 22.04 with Kernel 5.15.0-76
Flash frequency
80MHz
PSRAM enabled
yes
Upload speed
921600
Description
Running version v2.0.10, using any sketch, when it comes the moment to compile the core, I always get the same error. Downgrading to v2.0.9 solves the problem.
Sketch
/*
Blink
Turns an LED on for one second, then off for one second, repeatedly.
Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO
it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set to
the correct LED pin independent of which board is used.
If you want to know what pin the on-board LED is connected to on your Arduino
model, check the Technical Specs of your board at:
https://www.arduino.cc/en/Main/Products
modified 8 May 2014
by Scott Fitzgerald
modified 2 Sep 2016
by Arturo Guadalupi
modified 8 Sep 2016
by Colby Newman
This example code is in the public domain.
https://www.arduino.cc/en/Tutorial/BuiltInExamples/Blink
*/
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin LED_BUILTIN as an output.
pinMode(LED_BUILTIN, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(LED_BUILTIN, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}Debug Message
Compiling core...
bash -c "echo '-DARDUINO_CORE_BUILD' > /tmp/arduino_build_925905/file_opts"
>: -c: line 1: unexpected EOF while looking for matching `''
>: -c: line 2: syntax error: unexpected end of file
exit status 2
Error compiling for board Adafruit ESP32 Feather.
Other Steps to Reproduce
Tried executing the bash command that fails manually. It does not fail.
I have checked existing issues, online documentation and the Troubleshooting Guide
- I confirm I have checked existing issues, online documentation and Troubleshooting guide.